PIRETTI 2000 TASK — Arm Height
The button to adjust arm height is located on the outside of the arm support.

Press the button to raise or lower the arm.

The arm height should be adjusted such that your shoulders are not “hunched”, but are relaxed.

PIRETTI 2000 TASK — Arm Width
The “switch” to adjust arm width is located underneath the front of the armcap.

Push the switch to move the armcap in or out. Release the switch to lock the armcap in place.

PIRETTI 2000 TASK — Back Angle
(Depending on the model you have, this option may or may not be available).

The lever to adjust back angle is located at the right rear of the chair.

Move the back to the position you prefer and pull up on the lever. The back will flex, but only from that new position you have selected.

To return the back to its normal upright position, pull up on the lever again.

PIRETTI 2000 TASK — Back Height
To adjust back height, grasp the lower edge of the back with both hands and raise the back to the desired position.

If you have gone too far, then raise the back to its highest point and allow the back to drop to its lowest point.

Adjust back height such that the chair back follows the natural curve of your back.

PIRETTI 2000 TASK — Forward Seat Lock
(Depending on the model you have, this option may or may not be available).

The lever to lock the seat in a forward tilting position is located at the right front of the seat.

To lock the seat in a forward tilting position, shift your weight forward on the seat, then push the lever in.

To unlock the seat tilt, shift your weight forward on the seat, then pull the lever out.

PIRETTI 2000 TASK — Seat Height
The lever to adjust seat height is located at the left front of the chair.

To lower seat height, raise the lever while you are seated in the chair.

To raise seat height, take your weight off of the seat and then raise the lever.

PIRETTI 2000 TASK — Tilt Tension
The knob to change the tension of the seat is located underneath the chair.

Turn the dial counterclockwise to lower tension and clockwise to increase tension.